Table of Contents
Advertisement
Quick Links
1. BEFORE YOU BEGIN
HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions.
SPECIFICATIONS
S
K-705230: (15-3/8" (39.1cm) – 16-3/8" (41.6cm)) x
(26-1/16" (66.2cm) – 28" (71.1cm)) x
(15-3/8" (39.1cm) – 16-3/8" (41.6cm) x
72" (182.9cm).
S
K-705231: (26-3/4" (67.9cm) – 27-3/4" (70.5cm)) x
(26-1/16" (66.2cm) – 28" (71.1cm)) x
(26-3/4" (67.9cm) – 27-3/4" (70.5cm)) x
72" (182.9cm).
S
K-705232: (17-3/8" (44.1cm) – 18-3/8" (46.7cm)) x
(28-1/16" (71.3cm) – 30" (76.2cm)) x
(17-3/8" (44.1cm) – (18-3/8" (46.5cm) x
72" (182.9cm).
S
K-705233: (15-3/8" (39.1cm) – 16-3/8" (41.6cm)) x
(28-1/16" (71.3cm) – 30" (76.2cm) x
(15-3/8" (39.1cm) –16-3/8" (41.6cm)) x
72" (182.9cm).
PREPARATION
Before starting the installation, lay out and identify all the
parts. Use the exploded view illustration on the following
page for reference.
Install shower receptor/module in accordance with instruc-
tions supplied with receptor/module. Finished wall material
should be completely installed at this time.
BC
116896-2-
R
1 1
ARICA
SHOWER ENCLOSURES
All information in these instructions is based on the latest
product information available at the time of publication.
Kohler Co. reserves the right to make changes in product
characteristics, packaging, or availability at any time with-
out notice.
These instructions contain important care, cleaning, and
warranty information – please leave instructions for the
consumer.
TOOLS AND MATERIALS REQUIRED
S
Conventional woodworking tools
S
Utility knife
S
Measuring tape
S
Level
S
Pencil
S
Safety glasses
S
Screwdriver - Flat
S
Caulking gun
S
Masking tape
S
Silicone Sealant (RTV)
S
Center punch
S
Hammer
S
Screwdriver - Phillips
S
Electric drill
S
Drill bit - 5/16"
S
Masonry bit for ceramic tile - 5/16"
S
Drill bit - 1/8"
S
3/16" Hex wrench
CAUTION: Risk of injury or product damage.
Tempered glass cannot be cut.
NOTE: For ease of installation, two people should install
shower enclosure.
NEO-ANGLE
Advertisement
Table of Contents
Related Manuals for Kohler ARICA K-705230
Summary of Contents for Kohler ARICA K-705230
- Page 1 Follow the sections that pertain to your Kohler Co. reserves the right to make changes in product particular installation. This will help you avoid costly characteristics, packaging, or availability at any time with- mistakes.
-
Page 2: Parts Identification
Glass Wall Spacer Anchors Decorative O-Ring #8-18 x 1-1/2” Pivot Cover Plate Panhead Screw Frame Cover/ Expander Door Seal Jamb Decorative Pivot Cover Drip Rail Return Panel Pivot Body Drip Rail Insert Door Frame 116896-2- Kohler Co., Kohler, WI U.S.A. -
Page 3: Installation
Align the outside edge of each wall jamb with the marks made on the receptor ledge. Using a level, plumb the wall jambs and mark the four wall-mounting hole locations on each wall with a pencil. “A” “A” Kohler Co., Kohler, WI U.S.A. 116896-2-... - Page 4 To convert between a left-hand or right-hand door, turn the door upside down. All of the following illustrations are for a right pivot door (panel swings open toward the right). Left Pivot Right Pivot 116896-2- Kohler Co., Kohler, WI U.S.A.
- Page 5 Do not set glass panel on its corners. F. REMOVE FRAME COVERS/DOOR SEALS FROM PIVOT DOOR Snap the frame cover/door seal out of each expander jamb. Set aside for later re-installation. Expander Jamb Frame Cover/ Door Seal Kohler Co., Kohler, WI U.S.A. 116896-2-...
- Page 6 Adjustment Screws Alternate turning the top and bottom adjustment (Six total) screws evenly on both sides to increase or decrease the door frame width. Adjust Screw Rotation 116896-2- Kohler Co., Kohler, WI U.S.A.
-
Page 7: Final Adjustments
Insert two #8-18 x 3/4” panhead screws through the Expander Jamb bracket slots and into the corner post screwports and Bracket secure. Repeat for other bracket. Kohler Co., Kohler, WI U.S.A. 116896-2-... - Page 8 (with raised side towards glass) and thread on Outside Door Glass Insert the outside handle until secure. Handle Remove the paper backing from the logo and apply to the outside door handle (flat face). Glass Insert Logo 116896-2- Kohler Co., Kohler, WI U.S.A.
- Page 9 Place another O-ring in the pivot insert groove on the opposite side of the glass panel. Dampen O-ring slightly and push a decorative pivot cover into place on both sides. Repeat procedure for bottom pivot assembly. Groove O-Ring Decorative Pivot Cover Kohler Co., Kohler, WI U.S.A. 116896-2-...
- Page 10 Carefully apply a bead of silicone sealant around the outside (dry side) of door where: 1) Bottom frame meets the shower ledge. 2) Wall jambs meet the shower walls. 116896-2- Kohler Co., Kohler, WI U.S.A.
-
Page 11: Important Consumer Information
Kohler Warranty, its benefits, and limitations. Kohler Co. and its distributors support you with one of the largest Kohler Co. will, at its election, repair, replace, or make Service Networks of its type. Here’s what you need to do appropriate adjustment where Kohler Co. inspection... - Page 12 Questions? Problems? First review the installation instructions to ensure correct installation. For additional assistance, call our Customer Service Department for direct help. You may also contact us at our web site listed below. In the U.S.A., call 1-800-4-KOHLER In Mexico, call 001-877-680-1310 In Canada, call 1-800-964-5590 www.kohlerco.com...
Need help?
Do you have a question about the ARICA K-705230 and is the answer not in the manual?
Questions and answers