Advertisement
4. There is an included aluminum bracket if you do not wish to drill into the exterior of the truck. This is
the same style 90º bracket that is used for the trailer plug.
5. Connect the 10m (32 ft.) harness(s) to the 4-pin connector on the rear of the vehicle. Run the harness
from the rear of the truck to the area where the monitor/display is located.
I NSTALLATION: Stand alone Monitor
1. Connect the 4pin harness to Video 1 on the monitor.
2. If using a 2-camera system connect the second 4-pin harness to Video 2 on the monitor.
3. Connect the RED 12V power to an accessory power. Ground the BLACK wire to a good clean body
ground.
FOR USE:
1. Connect the coiled 4pin harness to both the truck and the trailer connectors.
2. Activate the monitor to view backup camera.
7803 Instructions 6/26/18
INSTALLATION INSTRUCTIONS
Page 6 of 7
KB
Advertisement
