Connecting Cables; Warnings And Advice During Installation - Panduit PES197 Manual

CONNECTING CABLES

a. Connect the Serial Cable between the machine and the computer.
b. Connect the AC cable to the rear input of the machine and to the proper AC source. Be sure to
verify the power required.
Serial socket for
PC, 25 pin male
Not Used
WARNING! To avoid electric shock the power plate protective grounding conductor
must be connected to a ground circuit that conforms to the National Standard.
WARNING! Remember to connect the serial cable to the machine while it is switched
off to avoid damaging the circuits.

WARNINGS AND ADVICE DURING INSTALLATION

•
The Identification Plate attached to the rear panel contains information about the serial number, the
type of machine, the necessary power supply and maximum current.
•
Before switching the machine on, be sure that all the cables have been connected correctly and that the
local power supply corresponds to that stated on the plate. The plate layout is as follows:
Model : Machine model
Type : Embossing mode
Volt : Power Supply
Hz : Frequency supply
Imax : Maximum current (Amps)
SN : Serial Number
Manufactured on
Fuse rating
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
Identification Plate
PES197 supplied with UL Plate
PES197/E supplied with CE Plate
Not Used
Key for service only
Page: 3 of 17
AC Input Main Switch
Fuse
7-2009