Problem Solving - Panduit PES197 Manual

The table below can be consulted as soon as the error code has been identified. Having corrected the error
condition, press PAUSE/START or FEED in order to restore the working state of the Embosser.

PROBLEM SOLVING

ERROR
E-00
E-01
E-02
E-03
E-04
E-05
E-06
E-10
E-27
E-28
E-29
E-30
E-38
E-39
E-48
E-50
E-53
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
CAUSE
Machine expecting the reset command
The loader is empty
The clamp has not picked up the plate
Embossing motor blocked
Drum blocked
Problem on the clamp's trolley
Problem on Clamp
The front cover has been opened.
Incorrect password
Lost Data on Main Board
Lost Data on Drum
Lost Data on Drum
Lost Configuration
Machine without setup configuration
Printer Off-Line
Drum motor blocked
"Single Punch" setup not configured
Press START
Fill the loader
Check that the plate is error free
Call Technical Support
Control the punches and if the problem
persists, call Technical Support
Clean and oil the trolley guide and
control that it moves freely.
The clamp has hit a fixed part of the
machine. Control the mask coordinates.
Close the cover and push START
Insert the correct setup password
Call Technical Support
Ref. Software Manual
Ref. Software Manual
Call Technical Support
Configure the machine setup
Connect the Printer
Check the punches and retry. If the fault
persists, call Technical Support
Re-send the parameters required
Page: 14 of 17
SOLUTION
7-2009