Oiling The Trolley Track And Clamp Guide - Panduit PES197 Manual

OILING THE TROLLEY TRACK AND CLAMP GUIDE

•
Apply light oil at the clamp's trolley track (X travel guide – top and bottom), moving the trolley
by hand back and forth to assure an even distribution of the oil and to control the fluidity of
movement.
•
Apply light oil at the clamp guide (Y travel guide – both sides), moving the clamp by hand back
and forth to assure an even distribution of the oil and to control the fluidity of movement.
Lubricate
X & Y Guides
Contact PANDUIT Tool Service for the maintenance items listed below:
Carriage Bearing
Dies
Punch Cams
Input Hopper
pushers
1. Heavy users and dusty environments need to be cleaned and lubricated more often based on
contamination.
2. X and Y guides: Clean grooves then use 3-in-One
Run "Card Test 14" on continuous to spread lubricant.
When the general maintenance is finished switch the embosser on and make sure that the front cover does block
all operations. If this is not the case, call for Technical Assistance, as one or more safety devices could be
damaged.
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
Every 6 months,
or as needed
Yes
Page: 16 of 17
Every year
High temperature red
Yes
High temperature red
Yes
High temperature red
Yes
Yes
®
oil.
Lubricant
3-in-One Oil ®
lithium grease
lithium grease
lithium grease
3-in-One Oil ®
7-2009