Machine Setup For Producing Plates; Adjusting The Loading Unit - Panduit PES197 Manual

MACHINE SETUP FOR PRODUCING PLATES

•
Unlock cover with cover key and open machine cover. (The cover will "latch" into the open position.)
•
Insert plates for embossing in the loader on the right side of the machine.
•
NOTE: The plates must be arranged in the loader with the Easy Feed humps facing up.

ADJUSTING THE LOADING UNIT

Height Adjustment
Adjust both height adjustment bars by loosening knobs ½ turn according to the marker plate being
processed. Position bars against the back of the plate, allowing some clearance so plates do not bind
while feeding. Tighten knobs to lock in place.
Width Adjustment
Adjust width by loosening knobs ½ turn and positioning them according to the marker plate being
processed. Position them against the side of the plate, allowing some clearance so plates do not bind
while feeding. Tighten knobs to lock in place.
Gate Adjustment
Factory set to .014 ± .002".
Marker Plate Hold Down Adjustment
Factory set to .015 ± .003"
Height Adjustment Bars
Gate
Adjustment
For Plate
Thickness
Marker Plate
Hold Down
Adjustment
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
:
:
:
Plate
Weight
Page: 8 of 17
Width
Adjustment
Bars
7-2009