Hopper Installation; Switching On And Controlling The Display - Panduit PES197 Manual

HOPPER INSTALLATION

EXTERNAL HOPPER - NARROW TAG INSERT
a. Install External Hopper (see photo).
b. Install proper External and Internal hopper inserts to match marker plate height. (see photo).
c. Place appropriate plate weight on top of stack. Close machine cover by unlatching lock
mechanism located in the left rear of inside cover.

SWITCHING ON AND CONTROLLING THE DISPLAY

The machine can be switched on with the main switch (located in back of machine).
NOTE: Prior to switching "on", make sure cover is closed.
The display will appear with the message as shown below:
E-00 PWR-ON STAND-BY STATUS – PRESS START
Press the PAUSE/START key on left side of the front panel beside the display. This activates a general reset
which, when completed, will leave another message on the display to indicate the Ready state of the machine.
If the machine does not start, check that the power supply is correctly set and that the main fuse has not been
shorted.
If error message appears, please refer to the "Error Messages and Problem Solving" section.
NOTE: If the display is turned on but nothing appears on the screen,
switch the machine off and call for Technical Assistance.
(see Regional Contact Information on Page 16)
The machine is now ready to run.
Open PANDUIT E
-M
ASY
Start E -M
ASY
the Password when requested by Login. Password is located on the CD.
Click OK to start the first work session with E
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
PANDUIT METAL EMBOSSER V.#.##
READY
software.
ARK
with a double click on the E
ARK
INTERNAL HOPPER - WIDE TAG INSERT
-M icon present on the desktop. Insert
ASY ARK
-M .
ASY ARK
Page: 9 of 17 7-2009