Production - Hopper; Console - Panduit PES197 Manual

a. Click FORMAT and select.
b. In "Quick Find" box, type in the plate number you are going to emboss.
(MMP350, MMP350H or MMP350HW38)
c. Type desired information onto marker plate.
d. Press PRINT. Follow software prompts.
e. Select communication port number (check the communication port number by going to the Windows
Device Manager).

PRODUCTION - HOPPER

The production cycle finishes with the unloading of the plate on the left of the Embosser. If the cycle is error
free, the Embosser returns to the initial READY STATE.
If errors have occurred during the cycle, the machine will signal the error code on the display and will still unload
the plate before stopping; the incorrect plate must be removed manually.
Please refer to the section on "Error Messages and Problem Solving" for a description of the errors that can
arise.

CONSOLE

The console of the PES197 and PES197/E has two units: a front display and a membrane keypad.
The following list describes the structure of the front control panel:
•
An LCD display (2 rows with 40 characters per row), which is used to indicate the operating
status of the machine.
•
A PAUSE/START key
•
A FEED key
•
A red colored LED (top) to signal any error
•
A green colored LED (bottom) to signal that the machine is switched on
The following list describes the structure of the Keyboard:
•
10 numeric keys (0 – 9)
•
6 function keys which enable the diagnostic functions of the machine
•
4 direction keys (
•
1 ENTER key which is used to confirm the commands
PES197 & PES197/E: PA25609A01_01
PES197 and PES197/E: ENGLISH
← → ↑ ↓
) for moving the cursor in the desired direction
Page: 10 of 17 7-2009