Texas Instruments TMS320C5545 BoosterPack Hardware User's Manual page 8

Overview
Follow the instructions below to run the out of box demo:
1. Insert the SD card with the out-of-box demo image and wave audio files into the MicroSD slot (J3) of
the C5545 BoosterPack.
2. Connect headphones or speakers to the 'HEADPHONE' port of C5545 BoosterPack.
3. Power ON the C5545 BoosterPack with the SW6 sliding switch (the board receives power through
either USB port or an attached LaunchPad).
4. Choose audio source as SD using SW3 when C5545 BoosterPack is powered ON.
5. Launch the equalizer application on the Android device.
6. Allow the application to enable Bluetooth, if not already enabled.
7. Press the 'scan' button to start scanning for the C5545 BoosterPack.
8. Press the 'connect' button once the C5545 BoosterPack is detected by the application.
9. Start playback by pressing SW2 or by speaking 'play' near the C5545 BoosterPack on-board MIC.
10. Slide the equalizer bars on the application to change the equalizer values of playback.
11. Observe the change in audio at headphone output while changing the equalizer values from the
application.
12. Pause the playback by pressing SW2 or by speaking 'pause' near the C5545 BoosterPack on-board
MIC.
13. Resume playback by pressing SW2 or by speaking 'play' near the C5545 BoosterPack on-board MIC.
14. Stop playback by pressing SW3 or by speaking 'stop' near the C5545 BoosterPack on-board MIC.
8
TMS320C5545 BoosterPack Hardware
Copyright © 2016, Texas Instruments Incorporated
www.ti.com
SPRUI90 – September 2016
Submit Documentation Feedback