TVS Apache RTR 200 4V ABS Race Edition 2.0 Owner's Manual page 88

6. During re-assembly, engage the drum sprocket
with the wheel along with the drive chain and
then assemble the wheel into swing arm.
7 . Re-assemble the other parts in the reverse order
of removal.
Caution
While assembling the caliper assembly ensure that the
slot provided in the caliper is properly located to the lug
provided in the swing arm assembly.
Always make sure that whenever the wheel is removed,
axle nut is properly re-tightened to the specified torque
and chain play is re checked and adjusted if required.
Note
During removal of rear wheel axle hold the drum sprocket
assembly with the hand as it may fall. Carefully hang the
drum sprocket along with chain in the swing arm itself.
Warning
Keep the toner ring upwards whenever the wheel is
removed in order to avoid damages to the toner ring.
Damaged toner ring affects ABS function*.
* Not applicable of non ABS type rear brake system
80
STORAGE PROCEDURES
For storage of your motorcycle for longer periods of
over a month and above, we recommend to carry out
the following steps:
1. Clean the vehicle thoroughly. Park the vehicle on
centre stand.
2. Warm up the engine and drain engine cum
transmission oil. Store the oil, if new, in a dust
free container.
3. Empty the fuel tank.
4. Turn the fuel cock lever to 'OFF' position.
5. Drain the petrol from the carburettor.
6. Remove the spark plug and feed in several drop
of engine cum transmission oil through spark plug
hole. Crank the engine few times and reinstall the
spark plug.
Caution
Do not park the vehicle on a slope or soft ground or else
it may fall.
During storage, the battery must be recharged on a
constant current battery charger at recommended
amperage atleast once in a month.