TVS Apache RTR 200 4V ABS Race Edition 2.0 Owner's Manual page 13

DO'S AND DON'T'S
Do's
Check the ABS warning lamp for any warning
™
before driving the vehicle.
Apply both front and rear brake for better
™
performance.
Apply continuous brake in ABS mode for better
™
performance. Do not pump.
Perform the periodic maintenance as per the
™
schedule.
ABS should be serviced only at TVS Motor
™
Company Authorised Main dealer / Authorised
Dealer.
Carefully remove the wheel during puncture /
™
tyre replacement to prevent toner ring damage
/ bend.
Keep the wheel in such a way that the toner
™
ring is facing upwards.
Always use recommended brake fluid. Use fresh,
™
clean brake fluid.
Use only the recommended make, type and size
™
of tyre (ABS tuned with tyre specified by the TVS
Motor Company).
Don't's
Do not use non-standard tyres.
™
Do not pump the brakes. Apply the brakes
™
continuously.
Do not ignore any warning lamp on speedometer.
™
Do not adjust the wheel speed sensor air gap
™
your self.
Do not run the engine and ride or rotate the rear
™
wheel alone in gear with vehicle on centre stand,
for drive chain lubrication, during water wash etc.,
Do not attempt to correct the toner ring teeth by
™
bending manually or by using any other mode.
Warning
ABS only helps in improving the vehicle control. It is
always good to remember not to exceed the physical
limits of the vehicle stability. It is rider's responsibility to
ride at a suitable speed, while taking care of conditions
and road surface. ABS will not compensate for errors
in the judgement or improper brake use in the various
situation. ABS never eliminates the danger of falling
while turning.
Hard braking during sharp cornering on slippery surface
may lead to vehicle instability. Under such circumstances
gradual braking is recommended.
5