TVS Apache RTR 200 4V ABS Race Edition 2.0 Owner's Manual page 87

3. Place a support below the frame to prevent
vehicle from falling and lift the vehicle up.
4. Carefully dislocate the disc from the caliper
assembly and slide the wheel out.
5. Reverse the procedure for reassembling.
Warning
Ensure proper seating of disc in the caliper assembly
while reassembling the wheel.
Keep the toner ring upwards whenever the wheel is
removed in order to avoid damages to the toner ring.
Damaged toner ring affects ABS function.
REAR WHEEL REMOVAL AND REASSEMBLY
1. Remove the wheel hugger rear.
2. Remove the axle nut (1) along with the washer
and partially pull out the axle (2).
3. Take out the caliper assembly along with the
wheel speed sensor* by dislocating it from the
disc and the swing arm lug.
4. Carefully hang the caliper assembly in the swing
arm itself. Take out the spacer and pull out the
axle fully.
5. Remove the wheel assembly by gently tapping it
along with the disc and toner ring*.
1
* Not applicable of non ABS type rear brake system
2
79