Battery Removal; Battery Installation And Connections - Coleman POWERSPORTS AT125-B Manual

Battery Removal

1. Remove the battery plate or battery belt.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to the ATV.

Battery Installation and Connections

WARNING
To avoid the possibility of explosion, always connect battery cables in
the order specified. Red (positive) cable first; black (negative) cable last.
An exploding battery can cause serious injury or death.
Battery terminals and connections should be kept free of corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire brush. Wash
with a solution of one tablespoon baking soda and one cup water. Rinse well
with tap water and dry off with clean rags. Coat the terminals with dielectric
grease or petroleum jelly. Be careful not to allow cleaning solution or tap
water into the battery.
61