Carburetor/Engine Idle Rpm Adjustment; Throttle Cable Free Play Adjustment - Coleman POWERSPORTS AT125-B Manual

Carburetor/Engine Idle RPM Adjustment

If the engine idle speed is not satisfactory, and all other conditions are
favorable, the carburetor can be adjusted as follows:
1. Warm up the engine by running the vehicle approximately five minutes.
2. Place the transmission in gear with the parking brake applied.
3. Adjust the carburetor idle screw in or out until the desired idle RPM is
reached. Turning the screw in (clockwise) will raise RPM. Turning the screw
out (counterclockwise) will lower RPM.
4. The standard idle RPM is 1500±10%.

Throttle Cable Free Play Adjustment

Throttle cable free play is adjusted at the handlebar.
1. Slide the boots off the inline cable adjuster sleeve, loosen adjuster locknut.
2. Turn adjuster until 1/16" to 1/8"(2 to 3 mm) free play is achieved at the
thumb lever.
NOTE: While adjusting free play, it is important you flip the throttle lever
back and forth.
3. Tighten the locknut and slide the boots over the cable adjuster.
75