Overview; Cleaning; Lubrication - Epson Perfection V10 Service Manual

EPSON Perfection V10/V100 Photo/V200 Photo/V350 Photo

6.1 Overview

This chapter explains the maintenance work necessary to keep this product in the best
condition and to prevent problems.

6.1.1 Cleaning

If the product is noticeably dirty, clean it being careful of the following points.
Especially when the Document Glass surface is dirty, fully clean it to remove all dirt
since the read image quality is directly affected.
Never use organic solvents, such as thinner and benzene,
C A U T I O N
because they may deteriorate or degrade the plastic and rubber
parts.
When using compressed air products; such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.
Exterior
After wetting a clean cloth with water and then completely squeezing water out of
it, wipe the exterior with that cloth. If the exterior is extremely dirty, wipe it with a
cloth moistened with a small amount of detergent.
Document Glass
Clean it with a clean, dry cloth. When the Document Glass is especially dirty or
has foreign matter on its surface, wipe it with a cloth moistened with a small
amount of pure water. If the Document Glass has traces of wiping after cleaning,
completely wipe it with a dry, clean cloth again.
Scanner inside
When the Upper Housing has been removed, much dirt and dust enter from the
outside. Therefore, reinstall the Upper Housing after fully air-blowing the scanner
inside and Upper Housing.
MAINTENANCE

6.1.2 Lubrication

Lubrication is required when any part of the Carriage Unit of the scanner has been
replaced or the Carriage moves with noticeably large operation noise. The specified
grease and the lubrication points are given below.
Be aware that excessive lubrication may mess the mechanism up or
C A U T I O N
lead to an operation failure.
Type
Grease
Lubrication
Point
Figure 6-1. Lubrication Point (1)
Overview
Table 6-1. Specified Grease
Name Part Number Supplier
G-45 1033657
Lubrication
Point
Revision B
EPSON
<Lubrication
point>
Carriage
Motor
(Refer to
4.3.7 CR
Motor P39)
<Oil type>
G-45
<Tool>
Brush
<Amount>
Moderate
amount
59