Afl Sensor B - Epson Perfection V10 Service Manual

EPSON Perfection V10/V100 Photo/V200 Photo/V350 Photo
When installing the Lamp Assy, match the two guide pins and
the positioning holes.
Route the Lamp Assy cables through the two hooks, six ribs,
and seven notches as shown below.
Hook
Rib
Notch
Guide pin and
positioning hole
Figure 4-41. Installing the Lamp Assy
DISASSEMBLY/ASSEMBLY

4.5.5 AFL Sensor B

1. Remove the Lamp Assy.
2. Disconnect CN4 connector from the AFL Main Board.
3. Remove the screw (C.B.P. 3x8, 5-7 kgf.cm.) that secures the AFL Sensor B, and
remove the AFL Sensor B.
Notch
Guide pin and
positioning hole
When installing the AFL Sensor B, match the two guide pins
and the positioning holes.
Route the AFL Sensor B cables through the five notches as
shown in Figure 4-42.
Disassembly of AFL
(4.4.3 Lamp Assy on page 45)
(Figure 4-36 on page 47 )
Figure 4-42. Removing the AFL Sensor B
Revision B
AFL Sensor B
C.B.P. 3x8
50