Epson Perfection V10 Service Manual page 38

EPSON Perfection V10/V100 Photo/V200 Photo/V350 Photo
When reassembling the Upper Main Board Shield Plate, match
the guide pin and the positioning hole, and insert the plate
under the Lower Main Board Shield Plate.
For the Perfection V100 Photo/V200 Photo/V350 Photo, make
sure to screw the Upper Main Board Shield Plate together with
the earth cable of the Harness TPU/Harness AFL.
When reassembling the Upper Main Board Shield Plate, be
careful not to get the CR Motor cable caught under the plate.
Upper Main Board Shield Plate
Insert position
Figure 4-11. Reassembling the Upper Main Board Shield Plate
DISASSEMBLY/ASSEMBLY
C H E C K
P O I N T
5. Disconnect CN1, CN2, CN4, CN7 connectors, and CN5 for the V350 Photo, and
CN8 for the Perfection V100 Photo/V200 Photo to remove the Main Board.
C.B.P. 3x8
Guide pin and
positioning hole
Figure 4-12. Removing the Main Board (Perfection V100 Photo/V200 Photo/V350 Photo)
Disassembly of Main Unit
Perfection V10 is equipped with a different Main Board to
Perfection V100 Photo/V350 Photo, therefore note that the number
of connectors differ.
CN2
CN1
CN7
CN4
CN2
CN1
CN7
CN4
Figure 4-13. Removing the Main Board (Perfection V10)
Revision B
CN8
CN5
38