Epson Perfection V10 Service Manual page 40

EPSON Perfection V10/V100 Photo/V200 Photo/V350 Photo
5. Remove the three screws (C.C.P. 3X8, 5-7 kgf.cm) that secure the CR Motor Assy.
6. Remove the CR Motor Assy from the Lower Housing.
7. Remove the Damper from the CR Motor Assy.
Damper
C.C.P. 3x8
Figure 4-16. Removing the CR Motor (1)
8. Remove the two washers and the two Gears, and remove the Timing Belt from the
CR Motor Assy.
CR Motor Assy
(Bottom side)
Washers
Figure 4-17. Removing the CR Motor (2)
DISASSEMBLY/ASSEMBLY
CR Motor Assy
Timing Belt
Gears
After replacing the CR Motor, make sure to apply G-45 grease
to the specified area.
Make sure to loop the Timing Belt over the shaft with the
larger Gear.
Attach the Dampers so that the thick side of them comes to the
side with the Gears, as shown below.
Disassembly of Main Unit
(Chapter 6 "MAINTENANCE" P58)
Timing Belt
The larger Gear
Damper
Figure 4-18. Reassembling the CR Motor Assy
Revision B
Thick side
40