Canon PC1000s Service Manual page 95

CHAPTER 2 USING THE MACHINE
[No. 02. 03,041
Use it to set conditions for RTN signal transmission. If an error occurs often when the RTN
signal is transmitted at time of reception, increase the parameters to loosen the RTN signal
transmission conditions.
The following error codes are associated with the transmission of the RTN
signal at time of reception:
##104, ##107, ##I 14, W201
The RTN signal transmission condition (1) is the ratio of the number of er-
ror lines in relation to the total number of lines per page of reception im-
ages.
The RTN signal transmission condition (2) is the reference valueg2 for burst
err~rs*~.
The RTN signal transmission condition (3) is the number of errors not
reaching the reference value for burst errors.
*
1 : transmission errors spanning several lines.
*2: If set to 'IS', a transmission error spanning 5 consecutive lines is
identified as a burst error.
If any of these conditions is detected while an image signal is being revised,
the RTN signal will be transmitted after receiving the procedure signal from
the transmitting machine. A higher parameter will make the transmission of
the RTN signal more difficult.
[No. 051
Use it to set the length of item (pause) automatically put between the access code an the
ID code when a number is dialed on an NCC (new common carrier) line.
[No. 061
Use it to set the length of time (pause) automatically put between the ID code and the
telephone number of the other party when a number is dialed on an NCC (new common car-
rier) line.
[No. 091
Use it to set the number of TSI comparison digits (last
XX
digits) for a telephone number
cross check.
[No. 101
Use it to set the length of time for line connection identification. If an error occurs often
because of the line condition at time of a communication, increase the parameter.
COPYRIGHT 82002 CANON INC. CANON PC1000slimageCLASSD800sREV. 1 AUG.2002
2-49