Canon PC1000s Service Manual page 78

CHAPTER 2 USING THE MACHINE
#SSSW-SW02: network connection conditions setting
Bit Function 1
0
Factorv settina
0
start-up
at
memory clear list out- prohibit do not prohibit
0
put fault
1
not used
2
not used
3
not used
4
not used
5
not used
6
not used
7
not used
[Bit 01
Use it to specify whether or not to put the machine in standby state if the memory clear
list is not generated when the power is turned on after an error has occurred (e.g., running
out of paper).
If set to
'1'.
the machine will generate a memory clear list and enters standby state when
the image data is cleared and the power is turned on.
If set to
'1'.
moreover, the following takes place:
1. The alarm sounds, and the machine waits for correction; specifically,
a. The
LCD
indicates
'CHECK PRINTER'.
b.
The machine will not start reception operation in response to arrival of data.
2. When an appropriate correction is made, the machine will automatically generate a
memory clear list. If an error (e.g., jam) occurs during output, the machine goes back to
1. above.
If set to 'O', on the other hand, the machine will sound the alarm and enters standby state.
COPYRIGHT 0 2002 CANON INC. CANON PG1 WWtmageCLASS D600s REV.
1
AUG. 2002