Table of Contents
Advertisement
Assembling the rails
To assemble the rails, complete the following steps:
__ 1. Using a tape measure, measure the distance from the outside of the front
__ 2. Locate the front and back rails for the left side. Position the rails as shown
__ 3. Using a #2 Phillips screwdriver, attach the rails together with two M5 screws
Figure 6. Assembling the left side rail
__ 4. Assemble the rails for the right side in the same way (see Figure 7 on page
mounting holes of your rack to the outside of the back mounting holes.
Record this measurement.
in Figure 6, with the front rail on top of the back rail. Spread the rails to the
distance that you measured in 1.
(the larger silver screws from the kit), as shown in Figure 6. Leave the
screws loose so that you can adjust the reach of the rails, if necessary.
Left Side Rails
Front Rail
10).
Chapter 2. Mounting the 87691VX Tape Autoloader in a rack
Back Rail
Insert Screws Here
9
Advertisement
Table of Contents
