Table of Contents
Advertisement
Counter w
Counter w
Counter weight
eight
eight
eight
Counter w
Counter w
eight
To improve stability on TRACKER models, extra weight
can be added by means of liquid-filled tyres.
The standard tyre valve is an universal air-water valve.
The tyres can be filled with liquid to max. 75% of their
total volume. The table below indicates the 75% volume.
T
y
e r
s
z i
e
9
5 .
x
4
" 4
9
5 .
x
4
" 8
1
1
2 .
x
4
" 4
1
1
2 .
x
4
" 8
1
2
4 .
x
4
" 6
1
6
9 .
x
3
" 8
1
8
4 .
x
3
" 8
2
0
8 .
x
3
" 8
1 litre = 0.264 US Gal.
1 litre = 0.22 Imp. Gal.
Use a mixture of water and CaCl
as described in table below:
CaCl
per litre water
2
200 g (7.1 oz)
300 g (10.6 oz)
435 g (15.4 oz)
WARNING! It is very important that the CaCl
added to the water and agitated until it is fully
dissolved. Never pour water on to CaCl
get CaCl
in the eyes, flush instantly with cold water for
2
at least 5 minutes and seek medical advice afterwards.
IMPORTANT! The tyres must be liquid filled to max. 75
% of total tyre volume. Fill only the qty. of liquid neces-
sary to obtain sufficient stability of the sprayer. Do not fill
liquid and CaCl
mixture in tyres without tubes!
2
To fill the tyres:
1. Jack up the wheel
and rotate wheel till
the valve is posi-
tioned at “12 o’clock”.
2. Remove the valve
body and fill liquid
until it reaches the
valve.
3. When surplus liquid
is drained through the
valve stem fit the valve body again.
4. Adjust tyre pressure and lower the wheel. (Please
refer to table for correct tyre pressure).
22
Sprayer setup
(TRA
(TRA
CKER models only)
CKER models only)
(TRA
(TRACKER models only)
(TRA
CKER models only)
CKER models only)
M
a
. x
t i l
e r
s
o
l f
q i
u
d i
1
0
1
1
0
8
1
3
3
1
4
4
1
7
8
2
8
5
3
9
0
4
6
6
to avoid frost damage
2
Protection to
-15°C (30.6°F)
-25°C (12.6°F)
-35°C (-5.4°F)
! If you
2
Recommended tyre pressure:
p
r e
y t
e r
NOTE! When filling the tyres the valve should be posi-
tioned at 12 o’clock and when adjusting the tyre pres-
sure, the valve should be positioned at 6 o’clock.
001
To empty the tyres:
1. Rotate wheel till the
valve is positioned at
“6 o’clock.”
2. Remove the valve
body and let out the
liquid. Retain liquid in
an appropriate
container.
is
2
3. To empty the tyre
completely the tyre is
inflated and a thin drain
tube is lead to the
bottom of the tyre. The
air pressure will now
empty the remaining
liquid.
4. Remove the drain tube,
fit the valve and inflate
the tyre to specified
pressure. See the table “Tyre pressure”.
NOTE! Disposal of CaCl
local legislation.
T021-0011
GB 05 10
has to take place according to
2
Advertisement
Table of Contents
