Turning Rim And Rim Plate; Permitted Rim Positions - Hardi Commander Plus SPC Series Instruction Book

Table of Contents

Advertisement

T T T T T urning rim and rim pla
urning rim and rim pla
urning rim and rim pla
urning rim and rim pla
urning rim and rim plate te te te te
Track gauge can be altered by turning rim and rim plate,
positions refered to as ‘+’ or ‘-’ position.
rim plate
hub

Permitted rim positions

WARNING! When altering track gauge by turning
rims and rim plates the maximum permitted offset
between centre wheel and hub flange must be
observed:
Max offset, hub flange and centre rim:
PHH6I9@SÀ‚qry HvÃ…v€Ã‚ss†r‡ Hh‘Ã…v€Ã‚ss†r‡
2200/2800
3200/4200
Overview
IMPORTANT! Tyre sizes 18.4 x 38” and 20.8 x 38”
are not permitted in any “+ position”, only use the
“- positions”.
16
Sprayer setup
T251-0020
ÅÃ#$
ÅÃ$$
ÅÃ""
ÅÃ$$
T251-0003
T251-0004
GB 05 04 04

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Commander Plus SPC Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Commander plus spb series

Table of Contents