Subscribe to Our Youtube Channel
Related Manuals for Clarke CFTJ500
Summary of Contents for Clarke CFTJ500
- Page 1 TRANSMISSION JACK MODEL NO: CFTJ500 PART NO: 7612635 OPERATION AND MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC12/16...
-
Page 2: Specification
INTRODUCTION Thank you for purchasing this CLARKE Transmission Jack, designed for use in the removal and installation of transmissions and differentials. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
2. Do not allow personnel to operate the jack unless they have read these safety precautions. 3. Ensure that the jack is in good working order. Have any damaged parts repaired or replaced immediately. Use genuine Clarke parts only. The use of unauthorised parts may be dangerous and will invalidate the guarantee. -
Page 4: Safety Symbols
20. Use appropriate safety equipment, such as protective footwear, when using this jack. 21. When replacing parts, use only those supplied by Clarke International. Refer to the parts list on page10. 22. Ensure that the jack is properly maintained, and lubricated at all times, and that no rust or other forms of corrosion is allowed to weaken any part of it. -
Page 5: Unpacking And Assembly
• 1 x Fixings Kit including chain Visually inspect all components to ensure that no damage was suffered in transit. Any damage should be reported to your CLARKE dealer immediately. 1. Mount the four saddle brackets to the saddle using the eight bolts supplied. - Page 6 OPERATING INSTRUCTIONS WARNING: BEFORE LIFTING, ENSURE THE SAFETY PRECAUTIONS ARE STRICTLY FOLLOWED. NO RESPONSIBILITY CAN BE ACCEPTED FOR INCORRECT USE OF THE JACK 1. Ensure the vehicle is in a safe state as mentioned in the safety precautions, ensuring the ground on which the jack is to operate is level and solid. 2.
-
Page 7: Maintenance
• Using an oil can, slowly top up the oil to the level then replace the filler screw. NOTE: Top up using Clarke hydraulic oil (Part Number 3050830). 6. After use, wherever possible, store the jack with the ram in its lowest position. -
Page 8: Parts List And Diagram
PARTS LIST & DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 9: Component Parts
COMPONENT PARTS Description No Description Operating Handle Screw Handle Socket Oil Filler Plug R-Clip Reservoir Hinge Pin Pivot Pin O-Ring Actuating Link Cup Washer Plunger Piston O-Ring Piston Shaft Back Ring Split Pin 4x40 Umbrella Washer Lower Ring Cylinder O-Ring Pump Washer Upper Ring Connecting Link... - Page 10 Socket Bolt M10 x6 Actuating Pivot Wingnut M6 Thrust Bearing 8200 Washer 6mm Washer Securing Hook Nut M10 Chain Threaded Shaft Chain Hook Pivot Handle Grip RELATED CLARKE PRODUCTS Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
-
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the CFTJ500 and is the answer not in the manual?
Questions and answers