Daily Alarm Function; Dimmer; Low Battery Indication; Precautions - Youshiko YC9430 User Manual

8.3 Daily Alarm Function:

Press " MODE/SET" button to select to view:

Time Time & Day of Week
When viewing the alarm time, hold "MODE" button for 3 seconds to enter alarm

time setting. Press "+" or "- "button to adjust the alarm time. Press "MODE"
button to confirm the setting.
Press "ALARM ON/OFF" button to switch alarm on or off. If it is on, "

shown on the LCD.
When alarming, alarm icon "

snooze alarm, ("
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.
Except "SNOOZE" button, press any buttons to stop the snooze alarm. Otherwise,

the alarm signal sounds for about 2 minutes, and then stops automatically.

9. Dimmer

Press "DIMMER" button to adjust the LED brightness.


10. Low battery indication:

The low battery icon "
low battery status. The batteries should be replaced.

11. Precautions

Use a pin to press the reset button if the unit does not work properly.

Avoid placing the clock near interference sources/metal frames such as computer or TV sets.

The clock loses its time information when the battery is removed.

Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas

The outdoor sensor must not be set up and installed under water. Set it up in away direct

sunlight and Rain
Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning

agents may scratch plastic parts and corrode electronic circuits
If there is any inconsistency of weather forecast between Local Weather Station and this unit,

the Local Weather Station's forecast should prevail. The manufacturer will not take
responsible for incorrect forecasting from this unit
Alarm Time ( "AL" shown on the LCD)
" flash. Press "SNOOZE" button to activate the
" flash on the LCD). The alarm will snooze for around 5
"will appear and indicating that thermo sensor is in
"
8