Time And Alarm Setting; Radio Controlled Clock; Manual Time Setting - Youshiko YC9430 User Manual

Please Note:
For Manual time setting, before you set the time, you must make the
Icon Disappear , by pressing the wave button and holding for 3
seconds.
8.

Time and Alarm Setting

8.1 Radio Controlled Clock:

After batteries inserted and main unit finishes receiving the transmission from

outdoor sensor, the clock automatically starts to scan the MSF time signal. Radio
Control Icon"
flashes，
Indicating now is receiving
MSF signal
The clock automatically scans the time signal at 2.00 a.m. every day to maintain

accurate timing. If reception fail, scanning stops ("
The clock can be set to scan the time signal manually by holding "WAVE"button

for 3 seconds. Each reception takes about 5 minutes. If receptions fail, scanning
stops.
Stop scanning by holding "WAVE"button for 3 seconds.

"DST" shown on the LCD if it is in daylight saving time mode.


8.2 Manual Time Setting:

Hold "MODE" button for 3 seconds to enter Clock/Calendar setting mode.

Press "+" or "-" button to adjust the setting and press "MODE" button to confirm

each setting.
(By keeping the "+" or "-" button pressed, could accelerate the process and reach
the desired value more quickly)
The setting sequence is shown as follow: 12/24 Hour, Hour, Minutes, Second, Year,

Month, and Day.
Note:
(1) Second adjusted to zero only.
(2) The time setting mode will automatically exit in 15 seconds without any
adjustment.
" flashes on the LCD.
turns on,
Indicating signal received
successfully
disappear,
Indicating signal reception
failed
" on LCD disappear)
7