OBH Nordica frutti piano black Manual page 21

Available languages

Cleaning and maintenance

Wash jug, lid and inner cover in water and some detergent after each use. Dry well before

storage. The parts are not dishwasher proof. Do not use abrasive detergents that may dam-

age the surface.

Use a damp cloth for cleaning of the housing. Let dry before further use and storage.

IMPORTANT! THE MOTOR UNIT SHOULD NEVER BE IMMERSED IN WATER OR ANY

OTHER LIQUID!

Safety instructions

Read the instruction manual carefully before use, and save it for future use.

Plug the appliance to a household outlet of 230V only, and use the appliance only for

the intended use.

Always unplug the appliance from the mains supply when not in use.

The appliance must not be immersed into water or other liquids.

This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning the use of the appliance by

a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance. Chil-

dren are not always able to understand potential risks. Teach children a responsible

handling of electrical appliances.

Check that the cord is not hanging over the edge of the table.

Do not place the appliance on or near hotplates, open ﬁre or the like.

The appliance should only be used under supervision.

10. The appliance should be handled with care, as the knife is very sharp! Do not touch the

knife while it is operating. Be careful that neither ﬁngers nor utensils get into contact with

the knife!

11. Always examine appliance, cord and plug for damage before use. If the supply cord is

damaged, it must be replaced by the manufacturer, or his service agent or a similarly

qualiﬁed person in order to avoid a hazard.

12. For additional protection the installation of a residual current device (RCD) with a rated

residual operating current not exceeding 30 mA is recommended. Ask your installer for

advice.