Danfoss CCR2 Installation Manual page 6

Installation Guide
5. Control start menu
6
SMT/SI
CCR2
Start process
After having switched the control detected
SD card on and verified the card memory, the
following will happen.
If the card is correctly placed, the control will
verify the present files:
• access
• one set
• allset
If the above - mentioned files are detected, the
control will ask whether they should be used or
aborted.
If no files (new card, used for the first time) there
will be no request.
The next control will automatically generate a
folder with the following files:
• folder ACCESS:
allow change of access code to menu (details
on request or www.danfoss.com)
No. LCD Display READING DESCRIPTION
1 Danfoss Welcome Menu
CCR - 2.60
2 SD Free Diagnosis: available SD card memory
... ..
3 SD Free Available memory In MB
512 MB
4 NO No SD card in CCR2
SD CARD! Only when no card in CCR2.
5 AccesCod Do you want to change code access to the control?
Read? Press simultaneously „+" and „▼" to change code access to settings.
Information appears only if SD card includes changed file code: ACCESS and changes were confirmed
6 AccesCod Changes were done!
DONE! Information appears only if SD card includes changed file code: ACCESS and changes were confirmed
7 AccesCod Reset was not done.
Aborted! Information appears only if SD card includes changed file code: ACCESS and changes were ignored.
8 OneSet Do you want to change all settings and create new settings on PC? Press simultaneously „+" and „▼"
Read? to make changes.
Inquiry appears only if on the SD card the CCR2 finds new settings predefined on PC file: SETTING.
Note: recommended only for service staff.
9 OneSet Changes were done!
DONE! Information appears only if the SD card includes a file with predefined SETTINGS: and changes were
confirmed.
10 OneSet A new setting was aborted!
Aborted! Information appears only if SD card includes changed file: SETTING and changes were ignore.
11 AllSet Do you want to use data from file: allset from SD card and change all settings in the CCR2?
Read? Press simultaneously „+" and „▼" to change all settings.
Inquiry appears always from second run of the control with SD card.
AllSet – can be used to remove settings from CCR2 to another CCR2.
12 AllSet Changes were done!
DONE! Information appears only when SD card includes AllSet file and changes were confirmed.
13 AllSet Changes of Allset were aborted
Aborted! Information appears only when SD card includes AllSet file and changes were ignored.
14 72254 Series number of CCR2 and number of software.
123456 Code used for services.
15 Thu On Day of the week: Mon, Tue, Wed, Thu, Fri, Sat, Sun.
12: 59: 32 Status of working schedule:
"On": disinfection permitted in set schedule ;
"Off": disinfection not permitted in set schedule
12: 59: 32 Real time: hour, minute, second
16 10/9/06 Real date
12: 59: 32 Real time: hour, minute, second
• folder DATA: file with record date
• folder SETTINGS with files
- allset: file with settings. Each time the of
control is switched on, setting parameters
are archived. This function provides
verification history of all settings
- arch.set: file with archive of all settings.
When switching the control on for the 2nd
time with the above - mentioned record file,
the request procedure for setting change or
abortion will start.
Display information during the start process
After switching the CCR2 control on, the LCD
display automatically presents the start menu.
The table below shows the various information
and change possibilities during the operation of
the CCR2.
VI.D1.E2.1R Heating Solutions