Advertisement
ASSEMBLY INSTRUCTIONS
STEP 9
Connect the cable from the Leg (1) that is attached to the
Frame End-CB (3a) directly into the Control Box (6). Then
Slide the Control Box (6) into the Frame End-CB (3a).
Connect the Cable (9) to the other Leg (1) and the Control
Box (6). Then Connect the Hand Remote (7) cable to the
Control Box (6).
Use the adhesive-backed Cable Clips (15) to secure the
cables so they are not loose and in the way.
STEP 10
We recommend having two people for this step. Grab the
fully assembled desk by the legs (not by the desktop) and
turn the desk right-side up. Adjust the pre-installed glides
on the Feet (2) as needed.
STEP 11
Plug the Power Cord (8) into a 110V outlet.
HOW TO ORDER
1.800.676.6123
IMPORTANT
You must reset the desk prior to use:
To reset you must push and hold the DOWN button on the
Hand Remote (7) until the table lift reaches its lowest
point. Release the DOWN button. Press and hold the
DOWN button again until the LED display shows "RST". If
you are not using an LED hand remote hold it for about 10
seconds. Release the DOWN button. Finally Press and
hold the DOWN button once more until the desk lowers,
slightly rises then stops. Release the DOWN button and
your desk is now ready to use.
To program up to four presets with the remote just use the
Up/Down buttons to find your desired height, then press
the "M" button followed by a number 1-4.
Once a preset button is pushed, the desk will move to the
programmed height. Make sure no obstacles are in the
desk's path and that it is not touching any walls.
|
sales@progressiveautomations.com
|
www.progressiveautomations.com
Page 6 of 7
Advertisement
