Advertisement
ASSEMBLY INSTRUCTIONS
STEP 1
Before you start make sure to lay out all the components
and hardware to ensure you have all the necessary parts
listed on the parts page. Separate the Frame Ends
(3a,3b) and you will find the Center Rails (4) inside.
STEP 2
Place one of the Legs (1) into the Frame End-CB (3a) making
sure that the bar is on the top side in relation to the Leg (
Then line up the holes on each Leg (1) with the holes on the
Frame End-CB (3a)
Insert four M6x14 Machine Screws (11) through the holes
on the Frame End-CB (3a) going into the Leg (1). Rotate
each screw with the supplied Allen Wrench a just a few
turns, then once all four are inserted you can tighten
them until secure. Do this for both Legs.
STEP 3
Take the Side Bracket (5a) and slide it into the Frame
End-CB (3a). Insert two of the M6x35 Machine Screws
(12) through the two holes in the top of the Side
Bracket. Use the supplied Allen Wrench to rotate each
screw a few turns. Once both the screws are inserted,
tighten until secure. Do this for both Legs.
HOW TO ORDER
1.800.676.6123
STEP 4
Slide the two Center Rails (4) into the two Frame Ends
.
1)
(3a,3b). Make sure the slots in the Center Rails are facing
inward and that they are closer to the top edge when the
assembled unit is upside down (see picture below).
STEP 5
Attach a Foot (2) with four M6x14 Machine Screws (11) and
tighten until secure in a cross-pattern. Do this for each Leg.
|
sales@progressiveautomations.com
|
www.progressiveautomations.com
Page 4 of 7
Advertisement
