Scalance X-300 Declaration Of Conformity - Siemens SCALANCE X-300 Series Operating Instructions Manual

Certifications and approvals
11.3 Product group XR-300M
Installation guidelines
The devices meet the requirements if you adhere to the installation and safety instructions
contained in this documentation and in the following documentation when installing and
operating the devices.
● "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
support.industry.siemens.com/cs/ww/en/view/27069465)
● "Industrial Ethernet / PROFINET - Passive Network Components" System Manual
support.industry.siemens.com/cs/ww/en/view/84922825)
● "EMC Installation Guidelines" configuration manual
cs/ww/en/view/60612658)
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their target
systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
Note
The test was performed with a device and a connected communications partner that also meets
the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with these
standards, adherence to the corresponding values cannot be guaranteed.
11.3.1.2

SCALANCE X-300 declaration of conformity

You will find the EC Declaration of Conformity for these products on the Internet at the following
address:
SCALANCE X-300 declaration of conformity
support.industry.siemens.com/cs/ww/en/ps/15296/cert)
1. Click on the entry "SCALANCE X-300 managed" in the navigation panel at the top edge of
the window and from the drop-down list that opens, select the entry for your product group.
2. Select the entry "Certificate" from the "Entry type"drop-down list.
Result: A list of the available certificates is displayed.
266
WARNING
(https://support.industry.siemens.com/
(https://
Operating Instructions, 11/2019, A5E01113043-24
(https://
(https://
SCALANCE X-300