Workrite Ergonomics Sierra Series Manual

Before continuing, initialize legs if you have not done so already
After all the legs and the switch are connected and the power cord has been plugged in, hold the
down arrow on the switch until the legs make a short motion down and then back up.
This initializes and synchronizes the table legs.
You must complete
this initialization
step or your table
will NOT function
properly.
+
1

Change display from inches to centimeters

a
Simultaneously press 1 & 2 and the Up or Down Arrow until the readout changes to show S5.
b
Press the "SET" button with a ballpoint pen (NOT paperclip) to change from inches to centimeters.
To return to inches, repeat the same process.
+
a
#1500152-Rev B
Sierra Series Workcenters
2 3
1
2 3
Special Settings
b
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
55 5
60
50
10
45 15
40
20
35 30
25
55
60 5
50
10
45 15
40
Hold down until
20
table moves
35 30
25
slightly upwards.