Table of Contents
Advertisement
PROCEDURE FOR FUNCTIONAL CHECK
OF REPLACEMENT COMPONENTS
1. Microprocessor Controller (Computer) Board
a. Phase 7 Non-Coin Models
1) Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
2) Start the drying cycle by pressing any of the preset
cycles in letters A-F.
3) Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)
SECTION X
47
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AD-170SE and is the answer not in the manual?
Questions and answers