Backlight, F3 Bl; Printing Parameters, F4 Ser - Adam Equipment HCB-J Jewellery Series Manual

7.3 BACKLIGHT,
The backlight may be enabled or disabled by the user. If the backlight is disabled the
battery life will be greater. The following settings are available:
AU bL
On bL
Off bL
1) Switch on the balance then press and hold the [Unit/Clr] key during the self-
checking test of the display.
2) After a few seconds, the display will show the first function F1 UNT.
3) Press the [Air/Liquid] key to select F3 bL .
3) Press the [Tare] key to view the current settings for the backlight.
4) To change the setting press the [Air/Liquid] key to scroll through and select a
new setting as shown above.
5) Press [Tare] to confirm and move to the next setting.
6) When F4 Ser is displayed press the [Tare] key to enter the parameter, the
[Unit/Clr] key to return to weighing, or press [Air/Liquid] to go to the next
function.
7.4 PRINTING PARAMETERS,
1) Switch on the balance then press and hold the [Unit/Clr] key during the self-
checking test of the display.
2) After a few seconds, the display will show the first function F1 UNT.
3) Keep pressing the [Air/Liquid] key until F4 SEr is displayed.
4) Press the [Tare] key to view the current setting.
F3 F3 F3 F3 b b b b L L L L
Sets the backlight to operate automatically when a weight is
placed on the balance or a key is pressed.
Sets the backlight to be on at all times.
Sets the backlight to be off at all times.
F4 F4 F4 F4 S S S S e e e e r r r r
20
© Adam Equipment Company 2012