Dro Installation; Mounting On The Support Arm; Mounting Of The Built-In Model - Fagor Innova 40i TS Installation & Operation Manual

3 DRO installation

There are two ways to mount the Innova 40i TS:
1- Mounted on the support arm.
2- Built-in model.
3.1

Mounting on the support arm.

The DRO may be mounted at the desired height and may be oriented at will.
The DRO is mounted on to the support arm using two set-screws.
3.2

Mounting of the built-in model.

The DRO is ready to be built into an operator panel or pendant. The name of this model is special, a
B has been added at the end of the product name.
Example: INNOVA 40i TS-B
Dimensions of the DRO and the window to insert it into.
The first figure shows the DRO dimensions. The second figure shows the dimensions of the hole
needed in the enclosure of the machine to built this model into.
On support arm
Built-in
40i TS - v1205 - Installation/Operation - (12/29)