Table of Contents
Advertisement
2.6.4
Turning function.
Function
Turning
Assistant for defining a turning cycle after having entered
the following data:
X: Starting diameter. Move the X axis until the tool
touches the part. Press X axis button to enter the position
value on the X axis. If the part diameter is known, its value
may be entered directly. Press Enter. The next field (box)
is activated.
Z: Initial Z axis value. Place the tool touching the part on
the Z axis. Preset a value and press the button for the Z
axis to enter the value of the Z axis display. Press Enter.
The next field (box) is activated.
X: Enter final diameter. Press Enter.
Z: Enter Z axis final value. Press Enter. Press Enter.
Cut: Enter cutting pass in mm. The DRO will use this value also as the safety distance to withdraw
after each pass.
Execute turning cycle. Move the axes until both axis displays read zero.
Run
Go on to the next execution step.
2.6.5
Calculator function.
Function
Calculator
It may be used to carry out mathematical and
trigonometric operations as well as preset the desired axis
with the result of the calculation or import the displayed
coordinate values into the calculator to carry out math
operations.
Different types of calculators may be selected at the
function bar: Arithmetic, trigonometric and for square
functions.
Numeric
Numeric calculator. Functions:
Trigonometric calculator. Functions: Sin, Cos, Tan.
Trigonom
Functions:
Square
To Exit the calculator Set an axis with the result or Insert a value into the calculator.
Function
Exit
Set
by pressing the Calc button of the function bar on the Preset screen.
Insert
Total number of steps.
Current step Nr.
+ - x /
Exit the calculator.
Set one of the axis with the result of the calculator. To do this, access the calculator
Enter the value of an axis, PI or 2PI into the calculator.
40i TS - v1205 - Installation/Operation - (11/29)
Advertisement
Table of Contents
