Changing The Conveyor Direction - Sartorius WM Series Operating Instructions Manual

} 0.3 mm
8

Changing the Conveyor Direction

You can change the direction of conveyance by turning the entire checkweigher around
(i.e., the checkweigher with frame; models WM35, 60 and 120).
Only one direction of conveyance is possible for checkweigher model WM6.
§ Install the checkweigher without its support trestle to have it facing in the desired direc-
tion. If the checkweigher has a support trestle, remove the 4 screws that attach the trestle
to the frame.
§ Separate the connection between photo sensors and control cabinet. Connect the photo
sensor cable in the control cabinet in accordance with the numbering.
§ Install the display and control unit (with column) on the other side of the checkweigher,
in accordance with the operating instructions.
Important Note:
Do not rotate the weighing platform by 180°.
§ Turn the checkweigher with its frame and re-fasten the photo sensor cable in according
with the numbering.
Overload Stops
Note:
The load receptors on models WM60..., WM120... and WM35LFP... are secured
by 4 overload stops (screws).
§ Following installation of the equipment and before commissioning, remove these over-
load stops as follows:
§ Remove the cover plate (SW 13 or 19).
§ Use the enclosed metal strip (thickness: 0.3 mm) to distance the load receptors by 0.3
mm.
Note:
The metal strip is shipped in a polyethylene bag inside the control cabinet.
§ Use the locknut to secure the setting.
§ Replace the cover plate and fasten with the screws.
!
Caution:
Always secure the load receptor on these models with the overload stops before
transporting the equipment.