Software Settings - DURKOPP ADLER M-TYPE DELTA Additional Instructions

Software settings

4
To activate the remaining thread monitor in the software:
1. Log in as a technician ( Operating Instructions).
2. Open the menu
3. Press the
4. Check in the section
5. Open the menu
6. Turn on the checkbox in the
7. Set each of the following parameters to the value 1.7:
8. Press the
 The control panel shows a prompt to restart the machine.
9. Switch off the machine.
10. Switch on the machine again.
11. Open the menu P > Main Parameters and press on the text next
12. Set the value to Monitor.
 The remaining thread monitor is activated.
Additional Instructions M-TYPE DELTA - 00.0 - 08/2019
Software settings
User: technician
Password: 25483
Machine Configuration and press the
Configuration button.
Configuration of the outputs button.
RFW/SSD button.
• t 06 02 (RFW limit, right side)
• t 06 03 (RFW intensity, right side)
• t 06 04 (RFW limit, left side)
• t 06 05 (RFW intensity, left side)
Navigation button.
to the parameter O 06 00
Navigation >
OUT06(A2.X22.02) if the value is set to 2.
Machine Configuration and press the
t 06 00 parameter.
Bobbin monitor mode.
Settings >
Input/Output
21