DURKOPP ADLER M-TYPE DELTA Additional Instructions page 15

Assembling the remaining thread monitor (1-needle machines)
Fig. 8: Assembling the remaining thread monitor (2)
⑤
①
③
(1) - Cable RFW sensor
(2) - Sensor block
(3) - Hose
(4) - Hose
(5) - Slot
5. Guide the sensor block (2) along below the machine.
6. Screw the sensor block (2) to the hook support using the screw (9).
Information
To allow for easier assembly of the sensor block (2), turn the handwheel
such that the movable blade can be swung out of the way by hand.
The sensor block (2) is positioned correctly when the sensor block abuts
on the casting. The light beam of the sensor will then hit the flat of the
bobbin through the slot (5) in the hook housing.
7. Feed the cable (1) and hoses (3) and (4) through the cable holder (6)
8. Connect the hose (4) to the elbow screw joint (8).
Additional Instructions M-TYPE DELTA - 00.0 - 08/2019
①
Make sure to use the hole that is closer to the hook.
and the cable duct (7).
⑥ ④ ⑦
(6) - Cable holder
(7) - Cable duct
(8) - Elbow screw joint
(9) - Screw
②
⑨
④
⑧
13