DURKOPP ADLER M-TYPE DELTA Additional Instructions page 22

Fig. 16: Assembling the remaining thread monitor (3)
(1) - Hose
(2) - Hose
(3) - Cable RFW sensor left
(6) - Cable RFW sensor right
10. Screw the sensor block (11) to the right hook support using
11. Screw the sensor block (13) to the left hook support using
Information
To allow for easier assembly of the RFW sensor blocks, turn the hand-
wheel such that the movable blade can be swung out of the way by hand.
Fig. 17: Assembling the remaining thread monitor (4)
(13) - Sensor block
The sensor blocks are positioned correctly when sensor block (13) abuts
on the casting. The light beam of the sensor will then hit the flat of the
bobbin through the slot (15) in the hook housing.
20
Assembling the remaining thread monitor (2-needle machines)
② ③ ⑬
the screw (12).
Make sure to use the hole that is closer to the hook.
the screw (14).
Make sure to use the hole that is closer to the hook.
⑫ ⑪
⑭
(11) - Sensor block right
(12) - Screw
(13) - Sensor block left
(14) - Screw
(15) - Slot
Additional Instructions M-TYPE DELTA - 00.0 - 08/2019
⑥ ①
⑮
⑬