Software Settings - DURKOPP ADLER M-TYPE DELTA D867 Additional Instructions

4
To activate the needle cooling in the software:
1. Log in as a technician.
The needle cooling has been preset in the software. Check anyway if
the set value is correct.
2. Open the menu
3. Press the
4. Check in the section
5. Press the
6. Open the menu
7. Select the ON setting.
 Needle cooling is activated.
Press the
16

Software settings

User: technician
Password: 25483
Machine Configuration and press the
Input/Output Configuration button.
Configuration of the outputs button.
if the value is set to 1.
button to exit the menu.
Machine Configuration and press the
Cooling button.
button to return to the main screen.
Navigation >
OUT04(A2.X28.2) (parameter t 57 30)
Navigation >
Additional Instructions D867 - 01.0 - 04/2020
Software settings
Settings >
Settings >
Needle