Parts Removal And Replacement - Signode AK200HDX-19 Operation, Parts And Safety Manual

6.0

PARTS REMOVAL AND REPLACEMENT

6.1 To remove the cam levers and lever for shutter
(see drwg. 464631, pos. 63, 64, 65, Page 33)
- Remove release pin (see drwg. 464631, pos. 58, page 33) and swing strap guide wedge
inclusive chain (see drwg. 464631, pos. 10, page 33) backwards. Also swing out the stop
device.
- Remove weld motor (see drwg. 464631, pos. 83, page 33) Attention - toothed belt!
- Push the grippers a bit forward, using a C-clamp to take the load off the cam levers.
- Remove socket head cap screws (see drwg. 464631, pos.35, page 33) and pull on lever
shaft (see drwg. 464631, pos. 33, Page 33).
- Remove lever shaft.
- Remove cam levers.
6.2 To remove loop grip "strap end"
(see drwg. 464655, pos. 7, Page 39)
- Remove spring retainer (see drwg. 464655, pos. 5, page 39) and the 2 PCs. pressure
springs with the guide pins.
- Open shutter (see drwg. 464655, pos. 1, page 39).
- Remove pressure pad for shutter (see drwg. 464655, pos.13, page 39)
- Remove socket head cap screw (see drwg. 464655, pos. 35, page 39).
- Pull out complete gripper.
6.3 To remove vibrator
(see drwg. 464655, pos. 25, page 39)
- Remove spring retainer (see drwg. 464655, pos. 5, page 39) and 2 pcs. pressure springs
with guide pins.
- Open shutter (see drwg. 464655, pos. 1, page 39).
- Remove pressure pad for shutter (see drwg. 464655,pos. 13, page 39).
- Remove socket head cap screw (see drwg. 464655, pos. 35, page 39).
- Remove connection bolt from vibrator and eccentric arm by removing the pin keeper (see
drwg. 464655, pos. 51).
- Pull out vibrator inclusive vibrator support.
Note: Cutter blade and vibrator bolt are loose and may fall down to the floor!
- Remove cutter blade and push out vibrator bolt (see drwg. 464655, pos. 24, page 39).
- Remove vibrator. Note, do not lose the 4 pcs. INA flat cage needle rollers, they must be
replaced again correctly (see drwg. 464655, pos.20, page 39).
Before you start with service please disconnect the chain. Remove
release pin (see drwg. 464631, pos. 58) and swing strap guide
wedge inclusive chain (see drwg. 464631, pos. 10, page 33)
backwards. Also please swing out the stop device by pull off the
catch pin 64643 Pos. 14 + 15, page 60)
14