Head Adjustments - Signode AK200HDX-19 Operation, Parts And Safety Manual

7.

HEAD ADJUSTMENTS

7.0 Re-adjustment of gripper, loop grip and vibrator are necessary if:
1. Cam levers are replaced.
2. Adjustment screws are replaced.
3. Gripper, loop grip or vibrator support are replaced.
Re-adjustment must be carried out as follows:
To begin with, set the adjustment screw for each setting according to the table "Normal setting
of the adjustment screw length AK200". Then fix the grooved collar in a vice (with soft pinch
bars) and tighten the lock nut.
Turn the adjustment screw into the cam lever until a gap of 1 mm remains between the cam
lever and the grooved collar. In case the gripping force is insufficient for welding joint, clamping
tip of strap or clamping strap end, re-adjustments as described in sections 7.1 till 7.3 should be
made.
Whenever re-adjustments have been made, it is necessary to maintain a remaining gap of 0.5
mm between the cam lever and the grooved collar after the proper pressure has been set, so
that the pressure still can be increased.
In order to accomplish this, the screw length "L" shown in the table may have to be increased.
Adjustment screw for „plunger 1" strap end clamped length approx. 30 mm
Adjustment screw for „plunger 2" Vibrator
Adjustment screw for „Gripper tip of strap"
Notched disc
Lock washer
Counter nut
Adjustment of screw length AK200
17
length approx. 32 mm
length approx. 30 mm
Adjustment screw
Lever