Setup Through A Dallas Key; Setup Through A Pc; Dynamic Codes - M-LOCKS Basic line Series User Manual

Setup through a Dallas key

Lock setup can be performed in two different ways only when the lock is in pre-setup, through a
setup Dallas key or directly thorough a PC connected to the keypad.
To open a lock in pre-setup press
Power up the keypad. Press and hold
message:
Enter the setup Dallas key into the reader and connect the reader the
the keypad through the jack connector. LCD will display the message:
Check displayed time and date, press
the values and then
If the operation is successfully performed LCD will display the
message:

Setup through a PC

Power up the keypad. Press and hold
message:
Press . LCD will display the message:
Start the programming on the Setup software or press

Dynamic codes

Power up the keypad. Press and hold
message:
Enter the dynamic user PIN or the Dallas key. LCD will display the
message:
Enter the dynamic code and press
Open within three seconds (green led).
If the lock is set to display closing code, LCD will display the
message:
M-LOCKS BV - Vlijtstraat 40 - NL-7005 BN Doetinchem - T +31 (0)314 376 876
IU_MiniTech_03
sales@m-locks.com - www.m-locks.com
.
to confirm or
to confirm. LCD will display the message:
.
. LCD will display the
to update
. LCD will display the
to exit.
. LCD will display the
PRESS 1 TO OPEN
SYSTEM SETUP
.....
08:00 FRY
27/01/2006
UPLOADING
.....
OPERATION DONE
PC LINK
PC LINK
...
DYNAMIC USER
X X X X
DYNAMIC CODE
X X X X X X X X X
CLOSING CODE
X X X
Page 7