Draytek VigorAccess User's Installation Manual page 61

4.3 Interface Stack (instance number)
Commands are shown as below:
Bridge Port (1~193)
|__ Ethernet (1)
|__ EOA (Ethernet over ATM) (192)
|__ AAL5 (vpi/vci, fast/interleaved) (192)
4.3.1 How to Change Management IP Address for Existing
Ethernet Port
Commands are shown as below:
// Aggregation Ethernet
$modify aggr intf ifname aggr-0 ip <new-ip> mask <new-mask>
or
// Non-Aggregarion Ethernet
$modify ethernet intf ifname eth-* ip <new-ip> mask <new-mask>
(*: 1 or 2)
4.3.2 How to Create more VC/EOA/Bridge
Commands are shown as below:
$create atm vc intf ifname aal5-* vpi <vpi> vci <vci> lowif atm-*
[vcmux/llcmux] [fast/interleaved]
$create eoa intf ifname eoa-* lowif aal5-*
$create bridge port intf portid <bridge-port-id> ifname eoa-*
4.3.3 How to Setup SNMP Community/Host/Trap
Commands are shown as below:
$create snmp comm community <community> RW
$create snmp host ip <host-ip> community <community>
$create snmp hosttrap ip <host-ip> community <community>
VigorAccess User Installation Guide
|__ ATM (max VCs) (24)
|__ DSL (line/alarm profile, ...) (24)
61