Draytek VigorAccess User's Installation Manual page 59

Once entering into DSL module, the command described in section "DSL Command
List" can be used.
- Display the current connectivity with DSL modules
Admin> dsl
- Login to DSL module in master via serial channel
Admin> dsl –c
- Login to DSL modules in master via Ethernet channel
Admin> dsl –s m
- Login to DSL modules in slave via Ethernet channel
Admin> dsl –s <salveId>
4.2 DSL Command List
4.2.1 How to Monitor DSL Status
Users can use the following command to check the status of DSL. The commands are
listed as below:
$get adsl atuc physical ifname dsl-*
$get adsl atur physical ifname dsl-*
(*: 0 ~ 23)
4.2.2 How to Enable/Disable a DSL Port
Commands are shown as below:
$modify adsl line intf ifname dsl-* enable
$modify adsl line intf ifname dsl-* disable
4.2.3 How to Read DSL Training Rate
Commands are shown as below:
$get adsl atuc channel ifname dsli-*
$get adsl atur channel ifname dslf-*
$get adsl atuc channel ifname dsli-*
$get adsl atur channel ifname dslf-*
(*: 0 ~ 23)
VigorAccess User Installation Guide
(for downstream)
(for upstream)
(for downstream/interleave channel)
(for upstream/fast channel)
(for downstream/interleave channel)
(for upstream/fast channel)
59