Powering On; Perform Surfacing - Roland MODELA MDX-15 User Manual

Powering ON

NOTICE
Before switching on the power to the MODELA, turn on the computer.

Press the STANDBY key.
The STANDBY LED lights up.

The unit performs initial operation and stops, and the VIEW LED and MODELING MODE LED light up.
* During initial operation, a sound may be heard for some 20 seconds at the time of origin detection.

Perform Surfacing

CAUTION
CAUTION
CAUTION
CAUTION
NOTICE
Do not perform cutting using cutting oil. Doing so may result in breakdown.
28 6 Operation Guide [Cutting Section]
Wear dust goggles and mask during use.
Cutting dust may scatter, causing bodily injury.
During cutting or scanning, do not place hands near the cut-
ting tool or the probe.
Doing so may result in injury.
Do not allow children to operate without adult supervision
or operate within reach of young children.
Doing so may result in injury.
Do not operate if a transparent cover is cracked or broken.
If the transparent cover at the front or the side of the unit is
cracked, contact a service agent immediately for repairs.