The Mounting Locations For The Spindle Unit - Roland MODELA MDX-15 User Manual



The Mounting Locations for the Spindle Unit

There are two locations (heights) for attaching the spindle unit.
Choose the correct location according to the cutting tool length and the thickness of the workpiece.
Spindle unit
Carriage
Spindle operating range
60.5 mm (2-3/8 in.)
Approximately
80.6 mm (3-3/16 in.)
Approximately
20 mm (13/16 in.)
Load the workpiece and install the tool. When using a base to load the workpiece, mount the base as well.
Make the layout the same as for actual cutting.
Move the spindle to its highest point. When viewed from the side, if the tip of the tool is lower than the surface of the work-
piece, remount the spindle unit at the higher location.
Make sure the tube is at the position shown in the figure.
Insert the cord for the spindle unit into the jack.
Tube
Make sure it is at the base of the cord.
Position the connector so the arrow points
to the back of the unit and insert.
Work plate surface
Spindle unit
Carriage
Spindle operating
range
60.5 mm (2-3/8 in.)
Approximately
Approximately 116.5 mm (4-9/16 in.)
56 mm (2-3/16 in.)
6 Operation Guide [Cutting Section] 23