Perform Cutting; Pausing Or Stopping Operation - Roland MODELA MDX-15 User Manual

Perform Cutting

A three-dimensional object is cut in two stages: draft cutting and finishing.
First pass
Draft cutting
Second
Finishing
pass
When finishing ends, cutting is complete.
Depending on the composition of the workpiece, however, finishing may not actual produce an attractive finish.
In such cases, use a file or the like to work it by hand.

Pausing or stopping operation

Press the VIEW key to quit the cutting operation.
To continue with cutting
Press the VIEW key again.
To end cutting
Stop sending data from MODELA Player.

High-speed cutting that leaves a margin for finishing
High-precision cutting of the margin on the workpiece surface left by draft cut-
ting
Click [START] to start cutting.
Open the [Printers] folder.
Windows 95/98/Me/NT4.0/2000:
Click [Start]-[Settings]-[Printers].
Windows XP:
Click [Start]-[Control Panel]. Click [Printers and Other
Hardware], then click [Printers and Faxes].
6 Operation Guide [Cutting Section] 33