Roland MODELA MDX-15 User Manual page 37


Remove fallen cuttings from around the workpiece and the table.
Metal cuttings
Remove using a commercially
available brush.

Remove any buildup of cuttings from under the table.
Metal cuttings
Detach the work plate.
While holding down the STANDBY key, switch on the power to MODELA.
Press the VIEW key and move the table. Use a commercially available brush to remove
any metal cuttings that are exposed.
After removing the cuttings, hold down the STANDBY key and switch off the power.
Other cuttings
Detach the work plate and use a vacuum cleaner to take up any cuttings.


Unplug the power-cord plug from the electrical outlet.
Other cuttings
Remove using a commercially available
brush or with a vacuum cleaner.
Lift up MODELA and also remove any cuttings that may
have fallen underneath.
6 Operation Guide [Cutting Section] 35